In the use of the CCTV Camera, you must strictly comply with the electrical safety regulations.
Do not connect several devices to one power source as an adaptor overload may cause
over‐heating and can be a fire hazard.
Please make sure that the plug is firmly inserted into the power socket.
When the product is installed on a wall or ceiling, the device should be firmly fixed.
If smoke, odor, or noise rise from the device, turn off the power at once and unplug the power
cable, then contact the service.
If the product does not work properly, please contact your dealer or the nearest service center.
Never attempt to disassemble the camera yourself.
Make sure the power supply voltage is correct before using the camera.
Do not drop the camera or subject it to physical shock.
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit
of ethanol and wipe it gently.
If the camera will not be used for an extended period of time, put on the lens cap to protect the sensor from dirt.
Do not aim the camera at the sun or extra bright places. A blooming or smear may occur
otherwise, and affecting the endurance of sensor at the same time.
The sensor may be burned out by a laser beam, so when any laser equipment is being used,
make sure that the surface of the sensor will not be exposed to the laser beam.
Do not place the camera in extremely hot or cold temperatures (the operating temperature
should be between ‐10°C ~ +60°C, dusty or damp locations, and do not expose it to high
To avoid heat accumulation, good ventilation is required for a proper operating environment.